The Way To Install A Dirt Bike Graphics Kit

Have you ever purchased an off-road graphics kit to refresh your motocross bike, but were scared to apply it due to fear of destroying it? These are the secrets that staff have used for decades to apply graphics fast and effortlessly.

What options are available to you?
The old saying is that there are many ways to skin a cat, that is true of sticker kits as there isn't any one right or wrong way to do this. This method is recommended by us as it's the most efficient and yields good results. It can also be simpler than other methods that rely on soapy water to get the graphic straight. You can obtain more information on dirt bike by visiting https://www.abcrnews.com/dirt-bike-graphics-are-all-the-rage/ site.

Other options are available to applying graphics to your bike. This includes elbow grease. But if you're not familiar with graphics, we wouldn't suggest using elbow grease. You have to be careful when you apply the graphics because they are very sticky and can't be ripped off easily.

Another option is to use a wet application using soapy water to lubricate materials and the sticker kit so you can apply the graphics and move the pieces around until you've placed them in the proper location. The downside is some think that, even when the soapy water dries there will be soap residue the remains beneath the dirt bike graphic kit weakening the adhesive and making the kit more likely to peel off in time.

How to go about it:
Make use of a heat gun, or hair dryer to pre-warm our graphics which makes them malleable and easier to apply. There is no need for soap to make the graphics stick. You can clean your hands prior to applying the stickers.

Step 1: Remove the old graphic kit from the areas you intend to put graphics on and you'll need smooth and clean surfaces for the best chance of your graphics appearing professional and remaining on. There might be some glue residue that remains on the plastics that is easiest to clean off using an alcohol-based cleaner. However, it's essential not to use any cleaners containing oil because this can damage the glue following installation.

Step 2: When your bike has dried completely, remove all your images from the box. Then, spread them out on the ground in the order they are to be placed on your bike.

Step 3. Now you're prepared to go for it! Select a portion of the dirt bike which is smooth and relatively flat for your first try instead of picking an uneven surface that can be tricky, we usually begin with the front fender , and then work our way to the back of the bike from there.

Some people like to remove the plastics from their bikes for applying graphics, however, we have found that on the full kit, there are some parts of the bike may not align perfectly straight and so keeping the plastics on the bike can help you get everything lining up straighter. You might want to remove your seat or certain pieces of plastic momentarily as some graphics are designed to fold over an edge and then stick to the tank's top, for instance, this would be much more difficult with your seat connected.

To check how the sticker will be positioned in the position you want, hold the sticker at the desired position. Once you're satisfied, peel away a small portion of the backing to leave a tiny section of adhesive exposed.

We will always have a straight section to start with, and if you line the initial part up correctly the remainder of the sticker should align correctly with the plastic, assuming the template for the sticker properly.